Build a Photo Transfer NAS Server with This Cable

Note: Compatible with both laptops and Raspberry Pi devices.

• The TurboLayer Cable is a high performance, cost-effective way to repurpose your old hard drive.
• Send photos directly from your phone to the connected drive.
• Supports either 3.5-inch or 2.5-inch SATA III hard drives with transfer speeds up to 6 Gbps.
• Just plug in the cable and the TurboLayer USB Stick to your laptop — and your Photo Transfer Server is ready to go.

Packing List

Power for the TurboLayer Cable

turbotenna

The TurboLayer Cable kit requires a 15–21V laptop power adapter with a 5.5 x 2.1 mm plug to power the included 12V power module.

This setup ensures a stable 12V output for your hard drives.

About the 5.5 x 2.1 mm Plug:

• 5.5 mm: Outer diameter of the plug.
• 2.1 mm: Inner diameter (pin hole) of the plug.
• This is a common type of DC power plug used for laptops and other electronics.

If needed, you can use a 5.5 x 2.1 mm plug splitter on the laptop power adapter to power both the laptop and the 12V power module at the same time.

5.5 x 2.1 mm SOCKET ===> 5.5 x 2.1 mm PLUG to Laptop
                                 ||
                                 ===> 5.5 x 2.1 mm PLUG to 12V Power Module

Check Your Hard Drive Interface

The TurboLayer Cable supports hard drives with a SATA interface only. It is not compatible with IDE interfaces. Please ensure your hard drive uses a SATA connection before placing an order.

turbotenna

Don't Forget to Specify Your Computer Platform

The kit works with both Windows 10/11 laptops and Raspberry Pi devices running the Bookworm OS.

Please make sure to specify which version of the TurboLayer USB Stick you need.

turbotenna